Sneaking up on completion

of the port side fuel tank. Had to go to mom's this afternoon, but I was able to glass the two top

flanges on the baffles. They are exactly at the same height as the flanges around the sides of the tank. Tomorrow I will trim the edges up and fill the depression in the middle. Then that part will be ready to glass the top on.
The next steps are to cut the top to fit and make the two areas where the bulkhead fittings for the fuel lines will be installed.
Then I can glass the top on and it will be done!!!
Except for the plumbing part....

I took the opportunity to glass up the 4 little holes at the back corners of the top flange.If you look closely in the very corner you can see the different pattern in the cloth.